🏰 Combo Unit Guide (Bounce + Slide)

Name: Bounce House Boise
Telephone: +1-208-510-5609

Follow every step in order. No shortcuts.

🚚 DELIVERY & SETUP

Ask the Customer: "Where do you want it placed?" and "Which way do you want the slide facing?"
Aim the Lip: All units are rolled back-to-front. Face the lip (flap) of the roll exactly toward where they want the SLIDE facing.
Know the Layout: Remind the customer that wherever the slide faces, the entrance will be on the left (if looking from the back) or on the right (if looking from the front). Usually, they want the entrance facing the main party area.
Unroll it flat.
Close Zippers & Vents: Zip all side zippers and close Velcro flaps. You MUST also check and close the vents at the bottom toward the slide or the rear, or it will not inflate.

Find the Outlet: Ask the customer where the plug is. It MUST be within 50 feet (only use 1 extension cord).
Tie the Cord: Connect the blower and extension cord together in a tight bow/knot so they don't pull apart.
Strap the Motor: Use a 2HP motor. Slide the sleeve completely over the edge of the blower and strap it dead tight. Make sure the sleeve is NOT twisted or blocking the air.
Flip the Switch: Turn on the blower. Manually lift the columns to help it prop up if needed.
🚨 TROUBLESHOOTING (If it won't inflate):
1. Double check all zippers, flaps, and vents under the unit (especially under the front slide lip or back corners).
2. If still lagging, add a secondary 1HP blower. Plug this second blower into a separate outlet on a completely different circuit so you don't trip the breaker. Ask the driver for an extra cord, or use the customer's if they provide one.

Stake it Down: Drive 1 stake at a 45-degree angle pointing away before inflation. Once fully inflated, drive the remaining 3 corner stakes in at a 45-degree angle.
Trip & Water Check: Ensure the extension cord is flat on the ground (no tripping hazards near the entrance) and kept completely away from water.
Water Hose Rules: Show the customer where the hose connection is. Let them know they can connect it if they want to use it—we do not do it for them. Advise them to only open the spigot a tiny bit (maybe 5%) so it doesn't spray all over the place.

Be Polite: Politely let the customer know you are there to pick up.
Clear Belongings: Check inside thoroughly for any people or personal items. Leave customer belongings in a neat pile for them.
Leave Basketballs: Small hoop balls stay inside the unit. Do not remove them.
Drain the Pool: If there is water in the slide area, step on the edge of the pool liner to let it all drain out. Getting the water out makes pickup way easier.
Kill Power: Shut off the motor, remove the sleeve, and open every single zipper on all sides. Step on the unit to stomp out as much air as possible.
Stash the Cords & Stakes: Roll the extension cord up and place it directly in the center of the flat vinyl so it rolls up with the unit. Roll the motor cord onto the blower. Put all stakes into the dolly container immediately so they don't get lost in the grass.

Fold in Sections: Fold the unit into 2 sections. Fold one side inward past the middle line. Fold the other side inward past the middle line. This folding is done along the left and right sides of the entrance.
Position Straps: Place your tie straps underneath the inflatable on each side toward the front slide area.
Back to Front ONLY: ALWAYS roll from the back of the combo up toward the front where the slide is. Roll it as tight as humanly possible, then tie it down secure with the straps.
Load Up: Prop your dolly up right next to the roll. Go to the opposite side, lift the roll up onto the dolly deck, and pivot it back. Stack the motor on top and head to the truck or trailer.