🏃 Obstacle Course Guide

Name: Bounce House Boise
Telephone: +1-208-510-5609

Follow every step in order. No shortcuts.

🚚 DELIVERY & SETUP

Ask the Customer: "Where do you want it placed?" and "Which way do you want the exit facing?"
Aim the Lip: All units are rolled back-to-front. Face the lip (flap) of the roll exactly toward where they want the FRONT EXIT facing.
Unroll it flat.
Close All Zippers: Walk around every side. Look for zippers on every single side, zip them shut, and close the Velcro flaps.

Find the Outlet: Ask the customer where the plug is located.
Rule of 50: The unit MUST be within 50 feet of the outlet because our extension cords are 50ft. No chaining cords.
Tie the Cord: Connect the blower cord to the extension cord and tie them together like a bow/knot so it cannot disconnect if it gets tugged.
Strap the Motor: Get a 1.5HP motor. Slide the sleeve completely over the edge of the blower so it can't slide off, and strap it down dead tight.

Stake Corner #1: When unrolled (before turning it on), drive 1 stake into a corner at a 45-degree angle pointing away from the unit.
Flip the Switch: Turn the blower on and let it inflate fully.
Help it Up: Stand by the unit and manually lift/prop up the columns if they get stuck while filling with air.
Stake the Rest (6 Total): Once it is fully blown up, drive the remaining stakes in at a 45-degree angle pointing away. You need 3 more for the other corners, and **2 stakes driven into the center points**.
Safety Check: Make sure the extension cord is flat on the ground (no tripping hazards around the entrance) and completely away from any water.

Polite Notice: If people are still there, politely let them know you are there to pick up the inflatable.
Clear the Unit: Look inside carefully. Check to see if there is anyone anywhere, and check for personal belongings. Leave any customer items in a neat pile for them.
Leave Small Balls: Small balls used for the hoops stay inside the unit. Do not remove them.
Open Everything: Turn off the motor, remove the sleeve from the blower, and open ALL zippers on every single side of the unit.
Flatten It: Step on the inflatable if needed to get it as airless and flat as possible.

Pack the Cord: Disconnect the extension cord, roll it up, and place it directly in the center of the deflated obstacle course. It gets rolled up inside it.
Motor Cord: Neatly roll up the motor cord on the blower itself.
Secure All Stakes: Pull all stakes out and place them straight into the dolly container right away. Do NOT leave them on the floor—they are hard to find in the ground and get lost in the grass.

Fold Longways: Fold the unit into 1 equal section. Get one side folded inward all the way to the end, then get the other side to do the same.
Straps Ready: Place the tie straps under the inflatable on each side towards the front exit area.
Back Entrance to Front Exit ONLY: ALWAYS roll from the back entrance to the front exit! Start rolling from the back entrance up toward the front exit where the straps are. Roll it as tight as you humanly can.
Strap it: When the roll is completely finished, use the tie straps to secure the inflatable tightly.
Dolly Load: Place the dolly next to the inflatable and leave it propped up. Go to the other side of the roll, lift it onto the dolly deck, and pivot it back. Mount the motor onto the load and take it out to the truck or trailer.